Donna Resin Booth 3,57m2

Technical Characteristics:

• Ext. Measurement: 188 x 190  x 225  cm.

• Int. Measurement: 175 x 180 cm.

• Weight : 80 Kg.

• Material: Resin

• Door Measurements: 120 x 183  cm.

• Type of door:Double hinged

• Type of joint: Screws and brackets

• Colour: Anthracite / White

• Roof: Gable

• Floor: Not included

• Window: Yes included

Steps to follow for the proper assembly of a shed:

• Choose a place where you can work without getting in the way of hedges or trees, you should have good access around the shed

• Before you start building any type of shed, the land must be leveled and the vegetation removed. If the shed is not level, the parts may be difficult to assemble. It is essential that the foundations are firm, so we recommend that they be concrete; There are also robust plastic bases that can be placed directly on the grass or deck

• Read the instructions, twice, and do not forget to refer to them. Some manufacturer's instructions are better than others, they can be a mixture of text and diagrams or only the latter, so it is very easy to make a simple mistake. Another good idea is to check if there are any instruction videos, official or not, on YouTube or anywhere else online. It may not be about assembling the exact same model, but it may give you valuable insight into a particular manufacturer's construction methods. 

• If the panels of plastic are left in the sun, they can expand and be difficult to assemble. So if you have to set up your shed in hot weather, find a shade where you can leave the panels. On the other hand, cold weather can also negatively affect plastic, so you'd better try to pick a day when the weather is mild and preferably windless.

Resin shed assembly:

• When unpacking the box, make sure you have all the parts by checking them against the instruction manual.

• First the floor is laid, fitting and/or screwing the panels together. The side panels are then placed around the edge of the floor, again simply sliding or snapping into place. At this stage it may be useful to insert a small piece of wood under the panels. The panels are also fixed with traditional screws or the manufacturer's own screw system, and are usually reinforced with steel brackets.

• A suitable wall panel may include a opening for the window, or it may be necessary to cut one in order to fit a window. Once the panels are in place, the doors can be added after fitting the handles, hinges and latches. The gables are then attached at each end and secured, roof gussets and, if included, the skylight are added.

To prevent condensation from forming in the shed, check that all panels, including all screws and washers, are in place so there is no chance of water entering the shed. You can also use silicone to seal the base rails. It is recommended to have a flat, level surface with a thickness of approximately 10 cm 

You can visit Marcas Area:  Gardiun

*Classic Plus Series, with 2 doors of 183 cm height.